After the canvas teepee tent has been used for many times, there must be some damaged parts, usually there are damaged parts, most of which are leaking stitches, holes in the rain cloth, and water seepage in the ground cloth. These damages can be repaired with suture glue. In addition, the rupture and damage of the camp pillars are usually replaced by new ones, so they are not described here. The following is a brief introduction to the treatment of suture glue:
When waterproofing sutures, you must first determine whether waterproofing is required, because not every suture needs to be treated with suture glue, usually exposed to rainwater, only sutures on puddles need suture glue, Therefore, the stitching of the rain cloth and the ground cloth must be waterproof. As for the inner wall of the inner tent, because it will not directly contact the rain, there is no need to be busy!
The second is to decide on which side to do the stitching glue treatment, usually on the inside of the rain cloth and ground cloth. To be precise, it should be on the other side with the waterproof membrane, that is, the side without the waterproof membrane treatment. suture glue. The easiest way is to drop some water on the cloth. If the shape of the water drop is still maintained, it is covered with a waterproof film. If the water will faint and spread out, that side is your target.
The next step is to apply suture glue, prepare a clean and dry toothbrush, remove the old bristles, then apply the suture glue to the stitches, and after the suture glue dries, pull the fabric tight Stretch the stitches to allow the glue to penetrate, then wait an hour for the glue to dry completely and you're done! Finally, use a sprinkler to sprinkle water to determine whether there is no water leakage. If there is still water leakage, wait until the fabric is completely dry before repeating the previous four steps!
canvas teepee tent https://www.szveg-forever.com/Outdoor-Tent